Need help fixing new a UTV roll cage

[plkracer]

I thought the same thing. Then again, I've heard quite a few rumors that it's a Wildcat frame adaptation, so if it's an Arctic Cat build, I'd not be surprised one bit.

Polaris' QA is similar to what the pix show too.

We pulled the cage off of an rzr to replace it with a race cage and it sprung 6 inches in one corner. I think all of the manufacturers are the same. The roll cage isnt very strong by itself.

[Bullnerd]

I know what to do, put it back together the way it came...and ride that FU!!ER!

[BorntoBraaap]

That is the correct answer../\ /\ /\ /\ /\

[stress]

Its a Yamaha . I am converting it to hand controls. I am working of trying to make a bar for the 5 point harness for the shoulders. The bar in the Yamaha roll cage is about 8 inches above my shoulders. I needed to get the plastic cargo bed panel out of the Yamaha to find a location for a shoulder belt bar to be around 3 inches below my shoulder. The only way I could the plastic cargo panel out of the Yamaha was to remove the roll cage.

I am posting a step by step tear down of the Yamaha at the link below
Tearing Down my YXZ1000 to mount five point harness - Yamaha YXZ 1000R Forum
If you want to see a Yamaha with no plastic there are many pictures. I trying to come up with a place to locate a shoulder belt bar. If have any comment about my bar location feel free to make comments in this post on minibuggy.net

[Bullnerd]

I had a feeling it was something to do with hand controls.

Keep us posted Stress, and again, congrats on your new ride.

[mech_head6]

I thought the same thing. Then again, I've heard quite a few rumors that it's a Wildcat frame adaptation, so if it's an Arctic Cat build, I'd not be surprised one bit.

FYI - the Yamaha and the AC UTVs are not tied at all. They each design and manufacture their own machines.

[K-fab]

FYI - the Yamaha and the AC UTVs are not tied at all. They each design and manufacture their own machines.

Good to know.