My ST3 Winter Project

[TWR11]

Sorry Diesel but you are about to start snapping off input shafts I canned three of them before I got it solved...
I just logged 950 sand miles at Glamis on the same chain but it's due for a new one now for the Oregon summer
Dale

Dale i think if you were to move the engine over to the drivers side 2" or so it might fix the problem so you can fit the pillow block between the tranny and the sprocket.

[Stomper]

Deisel62,
Just wondering how your project is comming along. I have been following it but have'nt seen any new posts lately. Please fill us in. Are you driving that beast yet.

[Diesel62]

Havnt done a thing on it since this spring, I had some medical issues come up and havnt been able to work in a very long long time so the toys had to get put on hold. Hopefully later this summer i can get back at it.

[wyattboche]

diesel62 did you get the bushings yet? Any progress?

[Diesel62]

Yeah i got the bushings a while ago. sent you a pm when i got them. Sadly no project is on hold for a while yet. Not sure when i will be able to get back on it, hopefully soon.

[wyattboche]

Just hopeing that you had the bushings installed and had some updates. Thats all.

[Stomper]

Havnt done a thing on it since this spring, I had some medical issues come up and havnt been able to work in a very long long time so the toys had to get put on hold. Hopefully later this summer i can get back at it.

I hope everything is alright, and look forward to more on your build.

[jumpin jellybean]

sorry to hear about medical issues thats always a bummer. great work so far hope you get better soon hate to have man down for too long

[ttginc]

Deisel62,
Any progress?