Buggy is setup for hydraulic clutch, engine has cable clutch...solutions?

[makenzie71]

Old engine used a hydraulic clutch, the 954RR engine i’m using is cable.

my options as i see them are to try and figure out a way to adapt a hydraulic clutch to the cbr or have someone build me a 15 inch cable and change my pedal setup completely.

how would you guys attempt to address this?

[K-fab]

Look and see if Magura makes a hydraulic conversion for it. They did a lot of them. It adds a small slave that bolts into the spot where the cable mounts and then runs a hydraulic line to the master cylinder.

https://www.magura.com/en/components...ilpage/?p=1853

[makenzie71]

Only 300 euros! Lol

makes me wonder why i can’t just use the slave on the buggy on a bracket to turn the lever...

[K-fab]

eBay. You should be able to find a slave.

https://www.ebay.com/sch/i.html?_fro...inder&_sacat=0

[CARLRIDDLE]

Slave cylinder. Speedway motors.
I made a little U goes on end bolts to arm on bike. Other end to a solid mount on frame. Run hydrolic line and boom. Just adjust so you don’t over pull arm. May have to put a pedal stop

[makenzie71]

I’ve been thinking along those lines but was afraid of overpowering the arm. Got a picture of your setup?

[taz79]

They make hydraulic to cable conversion kits for honda civics you might be able to make kne of tjose work