View Full Version : rzr motor mount pics please

08-14-2007, 01:03 AM
could some one please post pics of the front motor mount. the one under the exhaust manifold. i have a ridge runner that uses the same motor. and am having troubles with my front motor mount. one of the guys that works down and the ridge runner shop saw a razr today and said that the front mount is what i need to put in my buggy. so i am trying ot see what he is talking about. also if any one could post a expoloded parts diagram that woudl be very helpfull also with part numbers.

08-14-2007, 07:59 AM

08-17-2007, 01:00 PM
so here is what i came up with:








the original mount only has the rubbber motor mount, the cup it sits in and the the bracket going back to the motor. i add the angle iron the slotted tab and the adjustable stop that i will use as a tork stop. also i added the ford falcon tranny mount harder rubber. *with this on there now the motor has almost no deflection from load. when i used to put the buggy in gear and stand on the breaks the motor would deflect alot towards the right of the pictures which is actually to the drivers side of the buggy as the motor mounts facing forward like in the atv. so with this new set up i hope that i can quit ripping mounts apart. i also double checked all the other mounts while i was at it just to make sure they were good. so hope fully i can take it out and test it this weekend.

08-17-2007, 01:01 PM
BTW, are you going to be coming to the fall Moab trip, Ben came on the spring trip and seemed to really enjoy himself.
when is the trip. right now not looking good my fiancee just went back to work she has been out since april for our new baby.

08-20-2007, 08:05 AM

08-20-2007, 08:25 AM
On those motor mount repairs - add a small triangular brace on at least one end of the angle iron pieces you've welded in. *It will strengthen them a great amount and also help reduce the chance of high cycle fatigue cracking.

08-20-2007, 07:40 PM
ya i planned on it i just wanted to try it out to see if it would work. and so far so good.

08-20-2007, 07:46 PM

08-20-2007, 08:27 PM
now i have to tear it apart again to weld on the traingle piece and then realign it and hope that i can get it right again.... man i have my fingers crossed