PDA

View Full Version : Radiater hose



Azeriksis
07-01-2007, 08:58 PM
What kind of radiater hose do you guys use?I wanted too use flexhose but the smallest i could find is 1 1/4 inch ID.I want something that can be turned and bent without pinching the line.Any ideas?

Rico

Bugpac
07-01-2007, 09:12 PM
make it out of aluminum, then run short hoses...
I used 1" gates blue stripe heater hose on mine, it just has to sweep...

Azeriksis
07-02-2007, 12:26 AM
I dont follow what your trying too say.Will heater hose work? cuase i can get that in 1 id steel braided.I dont want too get burned if it springs a leak

Rico

boilermaker
07-02-2007, 10:42 AM
He means to make the main part, the middle section, out of tubing and just use hose on each end to connect all together. That way you will have a smaller amount of rubber hose to possible burst and you can clamp the tubing to the frame or anywhere out of the way for a clean looking routing. Look back at some of the builds for ideas, there are many great examples.