View Full Version : The Edge Products 2 Seater Vulture Rolling kit

01-03-2006, 10:56 PM
I think it costs about $14500 australian dollars as shown. CV rear driveline

01-04-2006, 08:50 AM
Very nice and simple car, I like it. Must be a bundle to ship over here. They sure seem to like the square tube.

01-04-2006, 08:54 AM
how much is that US?

01-04-2006, 09:51 AM
Times it by .75 for approx. USD. Or go to www.xe.com (http://www.xe.com) for an exact conversion.

01-04-2006, 03:37 PM
Can you buy the plans for that? Any demensions of the buggy?

01-04-2006, 03:50 PM
Go here http://edge.au.com to see info on the company. They sell single seat plans as well as finished buggies. They don't have info on this unit yet, and plans have been "in the works" for over a year.

01-04-2006, 08:41 PM
Nice looking car you have there, interesting placement on the front shocks. I really like the side panels, with venting to engine bay. keep posting pics as you progress.

01-04-2006, 09:52 PM
xqwzit, unfortunatly its not mine :( *cry* I was sent pics by the designer www.edge.au.com (http://www.edge.au.com) and i posted them here for all to see.

The pics you see was you get for a rolling kitset from the factory. Costs about Australian $14500 i think

I also think plans may be available in the near future :)

01-05-2006, 12:10 AM
Have you looked around at builders here in the US have? Most have rolling chassis options under $9000. Plus you can also buy just a frame (usually w/o tabs) for less than $1000 in some cases.

01-05-2006, 12:36 AM
nah i havnt really has a SERIOUS look at many of the US builders. In $USD the buggy above works out to be about $11000. At this time of my life i couldnt dream of coming up with the ammount of $$ (still a student at university) but if i did have the $$ id go with the Vulture as shown. Reason being as in my opinion The Edge Products (www.edge.au.com (http://www.edge.au.com)) would have to be the most inovative company in terms of offroading. Their design team certainly seem to know their shit