PDA

View Full Version : Post subject: 930 cv joint HELP!!!!!



chasevr
03-07-2018, 08:01 PM
Okay I bought a Protodie live axel spool for my engine swap. the thing I'm trying to figure out is.... Is there a 23 spline cv joint that will match up bolt pattern wise to a 930 cv joint???? I would like to keep my current axels and hub and save some money well a lot of $$$. I've been looking and looking but with no luck.... NEED GUIDENCE!!! Thanks much all...

studio5o
03-08-2018, 02:56 AM
Good to see you made it to the site ....welcome aboard.... to your question I had the same dilemma and unfortunately did not find anything as well ....I know that’s not what you want to hear but maybe someone here has more insight? Good luck with the build .

plkracer
03-08-2018, 04:25 AM
I used a front wheel drive rezeppa joint, and machined a step into it, made a flange, and welded it to the step. It was beyond tough, but took a little fabrication.

I think jgs turbo does the same or similar with the ford joints?

JGSturbo
03-13-2018, 12:16 PM
I used a front wheel drive rezeppa joint, and machined a step into it, made a flange, and welded it to the step. It was beyond tough, but took a little fabrication.

I think jgs turbo does the same or similar with the ford joints?
Yes. Don't be afraid to weld to CV outers, the large diameter makes it strong. 23-spline?