X2 Barracuda steering hubs

[Pieterholtz]

Just did a mock up of the front suspension and noticed I might run into issues with my steering rod connector brackets.
These are fouling with the lower swing arm at lock, and will not have any clearance when inserting a bolt to mount the rod end.

Are there any obvious reasons for this?
http://i1081.photobucket.com/albums/j343/Pieterholtz/Mobile%20Uploads/DSC_0073_zpsiqrqxj9g.jpg

http://i1081.photobucket.com/albums/j343/Pieterholtz/Mobile%20Uploads/DSC_0074_zpsg90rnpul.jpg

[deaner]

It looks like the bottom rod end is in too far. It needs room for a jam nut.

[Pieterholtz]

Do the top & bottom bottom swing arms run parallel with each other?
Assuming the X2 and the standard Barracuda run the same swing arm setup.