View Full Version : Odyssey Parts Exchange

02-02-2016, 09:12 AM
The following parts from other machines will fit the FL250:

*ATC110 CDI are the same part number and cheaper Honda # 30410-958-003/8

*1973 - 74 Honda CR250 head will bolt on to a Honda Odyssey FL250 engine

*Yamaha Warrior 350 Rear Hubs and Wheels – Direct bolt on, same splines use a couple of 1" washers for spacers

*Early 86-87 TRX250R/Fourtrax front hubs have the same bearings inside and out

*1975-1983 Goldwing 1000 Fuel Petcock is the same as the FL250

* Reduction Gear Chain #50 with master link.

02-03-2016, 07:57 PM
That's good info. Thanks for posting it.

02-03-2016, 11:01 PM
How about a pull start?

02-05-2016, 06:10 AM
Haven't found a replacement for the pull start. But I am working an idea using a Honda pull recoil starter. I am looking for a engine block with a crank in it to start on the design. Hopefully it can be made for between $25 to $75.

02-12-2016, 02:07 PM
This petcock kit, GL1000 / GL1100 Petcock Repair Kit (included in GL1000 and GL1100 Mast | Randakk's Cycle Shakk® (http://randakks.com/products/gl1000-gl1100-petcock-repair-kit-included-in-gl1000-and-gl1100-master-kit) will fit the Odyssey FL250.