View Full Version : roketa gk-32

06-24-2014, 03:32 AM
I have engine parts, trans parts and misc. Parts for sale

06-24-2014, 11:11 AM
Is this a trailing arm type rear suspension setup? if so, I'd be interested in the rear arms and hub assemblies.

06-25-2014, 03:32 AM
Just engine parts and trans
Im using arms

06-26-2014, 06:18 PM
NP, you may move the engine/trans on pretty fast with an ad for it over at buggynews as well---quite often there's lots of roketa guys needing that trans.

08-17-2014, 06:25 PM
XBird, i'va had my eyes out for a Rear Trailing Arm and hubs also. I used the hold bearing housing and made new arms off of that so I could use the same hub and axle stub.
They axle stub was a major pain in the ass to cut on my buddies industrial Lathe. It was a super Hardened steel that kept dulling the Lathe Cutter! You would think it would be cheaply steel that would cut like butter! It took me about 2.5 per each stub to cut it down so I could weld on the u-joint setup.

I'll keep you posted if I see any arms and hubs for sale.