View Full Version : New Aluminum Intake Manifolds for FL400 Pilot - 32-39mm carb

05-02-2014, 06:10 PM
Having some FL400 Pilot intakes made. These are cnc machined in the USA out of 6061/T6 aluminum bar. They are similar in design to the ones I had made for the FL350, but have the correct face angle as well as the Pilot stock port outlet dimensions.

Accepts the Mikuni-branded carb flanges and can run from 32mm to 39mm* carb on your Pilot. Rubber carb flange is NOT included. Use Mikuni carb flange M-VM34-200K for the 32-34mm carbs, and flange M-VM36-200K for 36-39mm carbs (Mikuni or Keihin).

*Running bigger-than-stock carb will require some plumbing for the airbox boot, since the stock boot is made for the stock carb.

The factory intake boots are damn near impossible to find, and if you do find one, its 20+ years old, dried, prone to air-leak, and tough as expired jerky. This new intake will solve all of these problems and also allow you some carb freedom.

Lead time from today is 2-4 weeks.

Kit includes:
(1) Intake Manifold
(2) M8x1.25 x 16mm bolts
(1) CD with the FL400 Pilot factory shop manual

Price: $116 shipped to lower US48.

Limited run! Over half the order is already sold. [smilie=eeek.gif] :eek:




06-25-2015, 03:26 PM
I've got about another 6-7 of these complete with flange, bolts, and manifold available the week after July 4th 2015. Smaller run, so price is $170 for a complete kit, shipped. If interested, let me know. Email me at danauxter2 at yahoo dot com.


[smilie=non_banana1: D$ [smilie=non_banana1:

08-27-2015, 04:24 PM
I've got 6 available with rubber flange, flange bolts, flange clamp, and shipping = $165 (USD).

Choose your flange: 34-35mm carb, or 36-39mm carb (Mikuni or Keihin).