PDA

View Full Version : brakes



bildlotsofshit
02-28-2012, 11:17 PM
I close to done with the cage and supenssion an my build.I have started to get on te brakes,I used honda 4 wheeler front spindles,hubs,disk brakes.For the rear i used polaris sportsman knuckles cv's brakes ect.My question is,what is the best way to go about the hydraulics for the brakes fron to rear.Ive concidered a proportioing valve and maybe a small car master or using both masters from the atv's and 2 adjustable ram/rods off the brake pedal, one to rear master and one to front master where i can adjust the 2 rods idividualy. Or maybe there is alot better way i havent thought of .Any input would b great.
Thanks

Lug-Nuts
03-03-2012, 05:08 PM
I actually have just had the same dilemma, I went with two master cylinders because i have them on hand. They are mounted together and I will be adding adjustable rods to them. I purchased banshee front hubs brakes etc, and I had the rear brake off the donor bike so Im just frankensteining these two together. Heres a pic, hope this helps.