PDA

View Full Version : inside dimension



moose79
01-23-2012, 02:20 PM
Im building a long travel ST2

what is the dimension from floor pan to underside of head bars AKA BARS TG

Glock n Ballz
01-23-2012, 04:55 PM
Moose,

Im not trying to sound like a smart ass...but I had to buy my plans from Bruce at Badland buggy. Wouldn't be fair if I just started handing over info. Sorry Charlie!
Cowboy up and buy a set.

moose79
01-23-2012, 06:36 PM
I bought a set already! If u could direct me to the page number where that dimension is written then please do!

nutz4sand
01-24-2012, 03:54 AM
It may not be printed as you likely may need to adjust it for the tallness of the passengers.

Should be a minimum of four inches and BETTER to be 6 inches from the passengers helmeted heads to the rollbar. While sitting in the mounted seats of course.

Glock n Ballz
01-24-2012, 05:29 AM
Ok moose! In that case no sweat.
Let me get back to you on that. Currently it's 5:28 am ...I'll take a look at that when I get a second.
I'm a pretty big boy too. Not 6' 4" but close at 6' 2"... I appreciate your concern.

moose79
02-01-2012, 12:26 PM
anyone????

Glock n Ballz
02-01-2012, 12:31 PM
anyone????

Sorry moose. I'll measure when I get home.

sqweeker
02-01-2012, 01:27 PM
On my ST2 it measures 42.5" to the bottom of the highest point of the bend in the bar that goes over your head.

I'm 6'1" and it should really be a couple of inches higher for me.

Good luck,
Ted

Glock n Ballz
02-01-2012, 01:44 PM
Yup, 42.5" I got the same.
I'm 6', 2" and I fit. Depends on how you mount your seat and what seat you use too.

moose79
02-01-2012, 02:23 PM
thanks guys