PDA

View Full Version : Building a tubing bender



Curt
01-01-2011, 02:17 PM
I purchased one from pro-tool.com. But they also have plans on building one. Depending on your skill level and tools they are pretty simple. I removed the bottle jack and installed a hyd cylinder and pump on mine. I have also had good service from them. Not sure how there dies are comparied to others in price. We made some at work and it was very time consuming.

jersdunz
01-04-2011, 08:46 AM
I could imagine, that is a lot of machine work..
to buy (http://www.pro-tools.com/105tdies.htm) them is most likely going to be much cheaper.
Especially if you need multiple sizes.