Activity Stream
-
Older Activity
-
Today, 03:31 PMdarwinpayne2000 replied to a thread Re-engine Buggy with a (modified) Predator 670 in Projects in ProgressA quick update on the minibike. I have the exhaust, the throttle and the seat in place. The gas tank still needs to be bolted down, then it's...165 replies | 20866 view(s)
-
Today, 03:15 PMI've been using a Lincoln Weldpak 100 120v welder from the get-go. I'm using the flux-core wire, not gas, so I can weld up to 1/4". You don't get...2 replies | 47 view(s)
-
Today, 02:18 PMConcept looks sound. lol on the monitor pic - I discovered the same a few days ago.120 replies | 15469 view(s)
-
Today, 02:16 PMHmmmmm.... I don’t know quads well enough to even begin to give advise on that (I run away from those wretched machines!) and a 2wd UTV, uh... What...38 replies | 6518 view(s)
-
Today, 02:08 PMIf you’re having to put all that effort into just getting it ready to be useable, may as well start out with new tubing and build from the ground up....2 replies | 32 view(s)
-
Today, 09:55 AMSell it and start again. Fix it and run it as is. Fix and improve on it in stages. What do you want. How much do you want to spend.2 replies | 32 view(s)
-
Today, 03:53 AMMy personal opinion on this (I'm not a materials expert) but looks more like surface rust to me. I'd guess it's pretty localize to where any water...27 replies | 1161 view(s) -
Today, 02:35 AMHi MBN community, over the summer of 2020 I acquired a badlands buggy st3 frame. Recently i just started to get on to working on it and the more I...27 replies | 1161 view(s)
-
Today, 02:34 AMHi MBN community, over the summer of 2020 I acquired a badlands buggy st3 frame. Recently i just started to get on to working on it and the more I...2 replies | 32 view(s)
-
Today, 02:00 AMI'm probably the last person to give welding advice, but yeah, if you see welds that look kind of sketchy, grind them out and reweld them. If a weld...2 replies | 41 view(s)
-
Today, 01:53 AMAny suggestions on what quad or UTV to get hubs from that's two wheel drive? Would it also be better to go with an OEM style or is there a better...38 replies | 6518 view(s)
-
Yesterday, 07:55 PMAnother Question: What do you do if the rust is inside of your tubing on your sand rail? My project St3 has holes in it for the flooring. When you...2 replies | 41 view(s)
-
Yesterday, 07:53 PMWhat do you do if the rust is inside of your tubing on your sand rail? My project St3 has holes in it for the flooring. When you look through the...27 replies | 1161 view(s)
