Activity Stream
-
Older Activity
-
Yesterday, 08:20 PMWell, other than higher sprocket wear, I can get 4,100 lb tensile rated #40 chain and still go with a single chain if 6.67:1 is enough reduction. I...202 replies | 17933 view(s) -
Yesterday, 03:35 AMBigger that rear sprocket is the closer it gets to the ground. Jack shift is twice the work and more parts to fail. I went jack shaft in the end....202 replies | 17933 view(s)
-
05-20-2022, 08:26 PMThanks guys; I’ll look for a sprocket with bearing. This would be so much simpler if I could just use #40 chain with 12T and 80T sprockets and not...202 replies | 17933 view(s)
-
05-20-2022, 05:26 AMThankyou for your amazingly kind response. :) I have since printed out the two pages of the wiring diagram and taped them together so it's all on...144 replies | 26219 view(s)
-
05-20-2022, 05:18 AMThat's what I went with.202 replies | 17933 view(s)
-
05-20-2022, 02:58 AMOn my engine the wiring was already chopped up when I got is as it was in another buggy so I had to stare at the wiring diagram for a long time and...144 replies | 26219 view(s)
-
05-20-2022, 02:39 AMI've got a urethane wheel on bearings for the chain tensioner and it's actually fairly loud as it moves from link to link when driving. I've not...202 replies | 17933 view(s)
-
05-19-2022, 04:56 AMI found a sprocket and bearing a fail proof way to go.202 replies | 17933 view(s)
-
05-18-2022, 11:24 PMRan out of square tubing for reinforcements so planning on using 1” round scraps I have from the previous frame chop. Also, I decided to use a...202 replies | 17933 view(s)
-
05-14-2022, 04:08 AMThanks bud. It's all a bit disheartening.144 replies | 26219 view(s)
-
05-13-2022, 08:12 PMI've never tried using a motorcycle engine in any of my builds and I don't think I'm going to start. Too many wires and sensors to trick and defeat....144 replies | 26219 view(s)
-
05-12-2022, 04:31 PMIt’s like the old saying goes “there’s no bad publicity”1161 replies | 189403 view(s)
-
05-12-2022, 10:44 AMHell, even if he said he screwed up and let the heat of the moment get the best of him, it would have been better than what he said. Not sure that...1161 replies | 189403 view(s)
-
05-12-2022, 04:26 AMHeadaches. For the bike to start it needs parameters meet. E.g.. Is the clutch switch ment to be an open or closed circuit when the clutch is...144 replies | 26219 view(s)
-
05-11-2022, 11:09 AMYa, he could have said he was trying to make a block pass, or he came in too hot and couldn’t avoid the contact. Not that most people would have...1161 replies | 189403 view(s)
-
05-11-2022, 11:00 AMAnyone heard if Craig is planning on riding a 250 again next year? I believe he can if he wants. Given his age, I'd think he would want to move up. ...1161 replies | 189403 view(s)
-
05-11-2022, 10:57 AMI remember someone saying it was more the diet that was the problem for them. Maybe it was Bubba from back in the day?310 replies | 73930 view(s)
-
05-10-2022, 11:26 AMCongratulations to Anderson. He sure proved me wrong in my early assessment of of his chances this year. With Dreamgate still humbling me, I admit...1161 replies | 189403 view(s)
-
05-09-2022, 11:04 AMHe wouldn’t have talked that way if he was the rider getting T-bone lol Mookie didn’t cut down early or anything, he just held his line and got taken...1161 replies | 189403 view(s)
-
05-09-2022, 08:10 AMAgreed. I don't know if Carmichael was just trying to play Switzerland or what, but he talked like he would have been okay with that move if it were...1161 replies | 189403 view(s)
-
05-08-2022, 11:58 PMVery nice. Good plan on the weather strip. Sounding like a chook shed on wheels would get annoying fast. Best of luck on the reg....223 replies | 42462 view(s)
-
05-08-2022, 11:35 PMI got the last couple obvious body panels put on this weekend. I also took them all back off and put on a combination of rubber washers under the...223 replies | 42462 view(s)
-
05-08-2022, 08:29 PMMan I was really thinking Mookie was gonna catch BamBam and take both of them out of the points chase for third. Kinda wanted to see him boot Barcia,...1161 replies | 189403 view(s)
-
05-07-2022, 09:09 AMAnyone have any info or thoughts on this. It looks old? Was out of a heap of stuff I got when my grandfather passed.0 replies | 117 view(s)
-
05-03-2022, 07:55 PMMan it's been 5 years, and hes only 32. He probably would have won a few more championships had he never left.1161 replies | 189403 view(s)
-
05-03-2022, 07:50 PMDungey should have never left. He left a ton of wins on the table.1161 replies | 189403 view(s)
-
05-03-2022, 05:31 PMHas anyone else seen that Dungey is supposed to be racing outdoors (a limited number of races) and that Jeffery Herling (MX GP champ) is going to...1161 replies | 189403 view(s)
-
05-03-2022, 04:04 PMI just read somewhere that the outdoors wont be on Peacock! WTF??????1161 replies | 189403 view(s)
-
05-03-2022, 03:46 PMStarted on A-arm reinforcements.202 replies | 17933 view(s)
-
05-02-2022, 10:15 AMI don’t mind the commentating during the race, I actually think it helps me keep up the stuff I would miss.1161 replies | 189403 view(s)
