02-11-2006, 08:36 PM
|
#1 (permalink) |
|
Senior Member
Join Date: May 2005
Location: San Diego
Posts: 149
|
No spark
I am repowering a single seat desert car using a 2004 GSXR600 and I am getting no spark. On my 2003 GSXR1300 Hayabusa powered car there is a resistor installed to fool the anti-theft provision and make it run... is there a similar set up in the 2004 GSXR600? I have the wiring diagrams for both motors and while similar, they are not the same... anyone come across this yet?
|
|
|
| Sponsored Links | ||
|
|
||
|
02-11-2006, 09:42 PM
|
#2 (permalink) |
|
Super Moderator
Join Date: Sep 2005
Location: Pacific Northwest
Posts: 1,279
|
Yes, the computer will be looking for something between about 2.6 and 5.5 volts. If lower or higher then no spark. If I remeber right the stock circuit delivers 3.5 volts to the anti-theft circuit.
|
|
|
|
|
02-11-2006, 10:40 PM
|
#3 (permalink) |
|
Senior Member
Join Date: May 2005
Location: San Diego
Posts: 149
|
With input from a minibuggy.net participant (Al), I ended up installing a 100 ohm resistor between the orange / yellow wire and the Red +12 volt wire and it starts and runs. The wiring requirements are different between the 600, 1000 and the 1300 GSXR's. Is this the correct way to bypass the anti theft, I dont know... there are no error codes and it runs so only time will tell.
|
|
|
|
| Sponsored Links | |
 |
| Bookmarks |
| Thread Tools | |
|
|
| Sponsored Links | ||
|
|
